Machine Positioning - Bosch TCE 4420 Manual Original

4.2.7

Machine positioning

1. Put back in place the side door.
2. Loosen the two screws that fix TCE 4420 to the
pallet.
Warning - damage risk!
The lifting belts can crush the flexible supply
pipes of the cylinder or damage the applied
parts of the TCE 4420.
€
Insert the lifting belts carefully.
3. Remove the horizontal sliding arm plastic protec-
tions and the rear protection of the locking lever.
Robert Bosch GmbH
Initial commissioning | TCE 4420 | 29
4. Insert the appropriate lifting belts (length belt 1: 1
Mt, belt 2: 3 Mt), with sufficient capacity, as shown.
2
!
Warning - tilting danger!
The barycentre of the TCE 4420 does not lie
in its centre.
€
It is necessary to lift the machine slowly.
5. Lift the TCE 4420 with a lift crane and install it in the
designed area respecting the minimum distances as
shown in the picture.
en
1
|
1 695 105 426 2010-02-16