Positioning Of Vertical Mast - Bosch TCE 4460 Manual Original

10. Connect the hose (C) at the lateral connection of
the pedal for the unseating unit, as shown in the
figure.
Fig. 16: Connecting the long hose
11. Connect the shorter hoses (D) to the connections
from the operating switch of the mounting column
(2 positions).
Fig. 17: Connecting the short hoses
!
Connect the machine to the compressed air system
and actuate the switch (G) to check that the moun-
ting column is operating correctly:
- RACING = mounting column up
- STANDARD = mounting column down.
Robert Bosch GmbH
Commissioning | TCE 4460 | 47
i
If the movement is not uniform, interchange the hose
connections at the switch connections (G). Once
the mounting column has been checked for correct
movement, disconnect the machine from the com-
pressed air system.
Fig. 18: Vertical movement of the mounting column
4.2.4

Positioning of vertical mast

1. Place one hand on the cover (at the top end of the
mast) and press downwards. With the other hand,
use a cutter to remove the adhesive strip and take
out the iron bar (A) between the arm and the moun-
ting head. Slowly move the hand on the cover of the
mast.
Fig. 19: Positioning of vertical mast
DANGER:
On account of the spring tension the vertical
mast may suddenly jump out of its seat and
pose a serious risk to the operator.
€
Extreme caution should therefore be taken
here.
en
|
1 695 105 428 2013-11-04