Angelcare AC1200 Manual Del Proprietário página 6

if you store the product over 30 days
because the batteries could leak and
damage the product.
16.12 Discard 'dead' batteries as soon as
possible since 'dead' batteries are more
likely to leak in a product. If a battery has
leaked or vented, it should be replaced
immediately using protective gloves.
16.13 DO NOT store this product, or the
batteries provided with or identified for
use with this product, in high-temperature
areas.
Warning
17.
(North America Only)
17.1 Modifications not authorized by the
manufacturer may void users authority
to operate this device.
17.2 NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15
of the FCC Rules and the Industry Canada
licence-exempt RSS standard(s). These
limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications.
FCC AND IC REGULATIONS
RF exposure warning
This equipment must be installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter. End-users and installers must be
provided with antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio
frequency exposure limits. The Wireless Device should be used in such a manner such that
the potential for human contact during normal operation is minimized. This device has also
been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure
conditions. (antennas that are greater than 1 m from a person's body).
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003 and RSS-210.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
6
All manuals and user guides at all-guides.com
17.3 However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment OFF and ON ,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
• Increase the separation between the
• Connect the equipment into an outlet on
• Consult the dealer or an experienced
17.4 CAUTION:
Any changes or modifications not expressly
approved by the grantee of this device
could void the user's authority to operate
the equipment.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful
2) This device must accept any
antenna.
equipment and receiver.
a circuit different from that to which the
receiver is connected.
radio/TV technician for help.
interference, and
interference received, including
interference that may cause undesired
operation.