Step 6 - Connecting The Camera(S) - Angelcare AC1200 Manual Del Proprietário

Monitor de vídeo, movimientos y sonidos para smartphones
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.2 - SETTING UP CAMERA(S) VIA
(NO INTERNET CONNECTION NEEDED)
1
NOTE:
For security reasons, we strongly
recommend that you change the
default password and create your own.

STEP 6 - CONNECTING THE CAMERA(S)

3
2
1
4b
All manuals and user guides at all-guides.com
ACCESPOINT MODE
1) On your mobile device, go to your Wi-Fi
2
2) Open the Angelcare App. Should a screen
3) Proceed to Step 9. (Step 6, 7, 8 only
1) Rotate the camera Adjustment Wheel
2) Press and hold the Activation Button
10 in
(25 cm)
3) Place your smart device (QR code facing
4) Align the QR code with the camera lens.
5) If the camera fails to successfully scan,
NOTE:
During the QR scan the volume of the camera's
speaker and brightness level will be at its
maximum setting.
settings menu and select the Angelcare
camera. It will be identified as AngelAC_
(+ Product ID number). The default
password is 12345678.
Note: It will appear on the right hand
side menu.
to select camera appear, close it. Within a
few seconds the video stream will appear.
Note: If the video stream does not
appear after 15 seconds, restart the app.
applies to WIRELESS SETUP).
to the top position.
for 3 seconds.
You will hear 3 increasing chimes
when it is ready to scan, and the
blue night light will start flashing quickly.
front) facing the Camera at a distance of
approximately 10 in. (25 cm) apart.
Note: If monitor fails to scan the QR code
(or user did not try to scan within 25 seconds)
a sound will let you know it failed to connect
and the flashing light will stop.
You will hear a sound and the frequency
of flashing will slow down and then stop
if your linking has been successful.
A Success message will appear. Press OK.
restart Connection steps from Step 1.
E
N
11

Publicidad

Tabla de contenido
loading

Tabla de contenido