Publicidad
Idiomas disponibles
Idiomas disponibles
Simulation box, digital/analogue
Switch position
Strobe switch
Bit 0 to bit 7 switches
LEDs bit 0 to bit 7
Potentiometer 1 to 2
Selector switch
Display
10
Comment
This strobe switch is the release switch for switches bit 0 to bit 7. In order to
create signals on switches bit 0 to bit 7, the Strobe switch must be set to the
left. If the signals set at switches bit 0 to bit 7 are to be simultaneously
output at a defined time, this can be achieved by pushing the Strobe switch
from the mid position towards the right.
With these switches you can set individual output signals or generate bit
patterns, if the Strobe switch is set either to the left or pushed towards the
right.
The LEDs indicate the sensor status of the hardware connected.
This potentiometer enables you to set output voltages of 0 V – 10 V DC .
The selector switch facilitates the selection of the displayed voltages V
V
or V
.
I1
I2
The display indicates the selected voltage in 4 digits.
, V
A1
© Festo Didactic GmbH & Co.
GB
,
A2
Publicidad
