Publicidad
Idiomas disponibles
Idiomas disponibles
Simulation box, digital/analogue
Switch position
Strobe switch
Output enable
Bit 0 to bit 7 switch
LEDs bit 0 to bit 7
Potentiometer 1 to 4
Selector switch
Display
12
Comment
The Strobe switch represents the enable switch for switches bit 0 to bit 7. The
Strobe switch must be set to the left in order for sensor signals to be created
at switches bit 0 to bit 7. If the signals set at switches bit 0 to bit 7 are to be
output simultaneously at a defined time, then this can be achieved by
pushing the Strobe switch from the mid position towards the right.
These switches enable you to set individual sensor signals or to generate bit
patterns if the Strobe switch is set either to the left or pushed towards the
right.
The LEDs indicate the status of the PLC outputs of the PLCs connected.
This potentiometer enables you to set input voltages from 0 V – 10 V DC.
The selector switch enables the selection of the displayed voltages V
V
, V
, V
or V
.
I1
I2
I3
I4
The display indicates the selected voltage in 4 digits.
, V
A1
A2
© Festo Didactic GmbH & Co.
GB
,
Publicidad
