Specifications; Sound Values And Vibration Values; Spare Parts And Accessories - Stihl MH 710 Manual De Instrucciones

19 Specifications

Fault
Engine running
roughly.
Heavy smoke forma‐
tion.
Excessive vibration
during operation.
Tilling performance
reduced.
Loud gearbox noise.
Drive shaft does not
rotate when clutch
lever actuated.
Oil leaking from gear‐
box or engine.
19 Specifications
19.1 STIHL MH 710 Tiller
– Displacement: 252 cm³
– Power: 5.2 kW (7.1 HP) at 3,600 rpm
– Drive shaft speed in first gear: 65 rpm
– Drive shaft speed in second gear: 128 rpm
– Drive shaft speed in reverse gear: 49 rpm
– Weight: 101 kg
– Maximum fuel tank capacity: 4,000 cm³ (4.0 l)
– Hoe diameter: 360 mm
– Working width: 970 mm
19.2 Sound Values and Vibration
Values
The K value for the sound pressure level is
2 dB(A). The K value for the sound power level is
2 dB(A). The K value for the vibration values is
3.20 m/s².
– Sound pressure level L
ance with 2006/42/EC: 86 dB(A)
0478-404-9905-B
Cause
Oil bath air filter dirty. ► Clean or replace oil bath air filter.
Incorrect fuel used.
Insufficient fuel in fuel
tank.
Oil level in engine too
high.
Oil bath air filter dirty. ► Clean or replace oil bath air filter.
Angle of machine
inclination over 15°.
Engine mounting
loose.
Hoes incorrectly
installed.
Hoes worn.
Blade spur incorrectly
set.
Blade spur incorrectly
set.
Drive belt worn.
Incorrect oil level in
gearbox.
Components in gear‐
box worn.
Cable defective.
Drive belt worn.
Components in gear‐
box or engine worn.
measured in accord‐
pA
Remedy
► Check fuel.
► Refill fuel tank.
► Drain engine oil.
► Place machine in horizontal working position.
► Tighten engine mounting bolts.
► Install hoes correctly.
► Replace hoes.
► Adjust blade spur.
► Adjust blade spur.
► Consult a STIHL specialist dealer.
► Check oil level in gearbox.
► Consult a STIHL specialist dealer.
► Check or replace cable.
► Consult a STIHL specialist dealer.
► Consult a STIHL specialist dealer.
– Sound power level L
ance with 2000/14/EC: 100 dB(A)
– Vibration value ahv measured in accordance
with EN 12096, handlebar: 8 m/s²
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
19.3 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
20 Spare Parts and Accesso‐
ries
20.1

Spare parts and accessories

These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
English
measured in accord‐
wA
23