Attaching The Front Wheel; Attaching The Blade Spur - Stihl MH 710 Manual De Instrucciones

English
► Place axle mount (1) on rubber tyre (2) so the
bores align.
► Insert bolts (3).
► Place washers (4) and spring washers (5) on
bolts (3).
► Screw on nuts (6) and tighten.
► Push running wheels (7) onto drive shaft (8)
so the bores align.
► Push folding retainers (9) through the bores in
drive shaft (8) and close the securing clips.
Running wheels (7) are secured.
6.2.2 Removing the Running Wheels
► Stop the engine.
► Pull out the folding retainers.
► Remove the running wheels.
► Push the folding retainers through the bores in
the drive shaft.
The folding retainers are kept in place.
10
6.3

Attaching the Front Wheel

► Slide front wheel (1) into frame (2) so the
bores align.
► Insert bolt (3) into the upper bore.
► Place washer (4) on bolt (3).
► Screw on nut (5) and tighten.
► Insert pin (6) through the lower bore.
► Push retaining pin (7) through the bore in
pin (6).
Pin (6) is secured and front wheel (1) is locked
in position.
The front wheel must not be dismantled again.
6.4

Attaching the Blade Spur

Assembling the blade spur
► Screw nuts (1) onto bolts (2) and screw into
the bores in adapter (3).
► Fit blade spur (4) into adapter (3) from below
so the bore on adapter (3) aligns with the low‐
ermost bore on blade spur (4).
► Insert pin (5).
► Push retaining pin (6) through the bore in
pin (5).
► Screw nuts (7) onto bolts (8) and screw into
the bores in adapter (3).
The blade spur is secured.
6 Assembling the Cultivator
0478-404-9905-B