Kit Assembly - Metra DP-3002 Instrucciones De Instalación

1. Install the (11) included panel clips to the
radio trim panel. The factory panel clips
may be used if desired.
2. Attach the radio brackets to the radio
and secure using the screws supplied
with the radio and slide into dash
opening. (Figure A)
3. Snap the radio trim panel over the
radio until it clicks in.
4. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Test the radio for proper
operation.
5. Reassemble the dash in reverse order of
disassembly.

KIT ASSEMBLY

(Figure A)
3
REV. 9/2/2020 INSTDP-3002