Important - Harbor Breeze SARATOGA II Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
1. Determine mounting method.
Downrod Mount (standard or angled ceiling)
IMPORTANT: lf angle mounting, check to make sure
the ceiling angle is not steeper than 20°.
2. Install mounting bracket (A) to outlet box (not included)
by sliding mounting bracket (A) over the two outlet box
screws (not included). Securely tighten two outlet box
screws.
IMPORTANT: If angle mounting, make sure open end
of mounting bracket (A) is installed facing the higher
part of the ceiling.
3. Remove preassembled pin and clip from downrod (E).
Save for later use.
1
2
Outlet box
A
3
E
Clip
Pin
6
ASSEMBLY INSTRUCTIONS
4a. STANDARD DOWNROD INSTALLATION:
Insert downrod (E) through canopy (B), canopy
cover (C), and yoke cover (D). Thread wires
from fan motor assembly through downrod (E).
4b. EXTENDED DOWNROD INSTALLATION:
If you are installing the fan with a longer downrod (sold
separately), insert it through the canopy (B), canopy
cover (C) and yoke cover (D). Then, thread lead wire
(N) through the downrod and connect the MALE plug
from the top of motor assembly (H) to the FEMALE
plug from the lead wire (N).
NOTE: The male plug of the lead wire (N) should extend
out of the other end of the downrod.
NOTE: The remainder of the instructions will reference
downrod assembly (E), but note all of the instructions
are applicable even if an accessory downrod was used.
5. Loosen preassembled set screws from yoke on
fan motor assembly (H). Slip downrod (E) into
housing yoke, aligning holes on both parts. Insert
previously removed pin through holes on yoke
and downrod (E), then insert previously removed
clip into pin until it snaps into place. Tighten set
screws.
4a
E
C
D
4b
C
D
Female Plug
Male Plug
H
5
E
Yoke
Clip
Pin
7
B
B
Set screw
H