Important; Downrod-Style Fan Mounting - Harbor Breeze WAVEPORT Manual Del Usuario

INITIAL INSTALLATION
4b. Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket
(C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19°.
5. Remove motor screws (J) and motor washers
(R) from underside of motor housing (D). [If there
are plastic motor blocks installed with the motor
screws (J) and motor washers (R), discard the
plastic motor blocks.]
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 9.

DOWNROD-STYLE FAN MOUNTING

1a.
Remove pin (L) and clip (M) from downrod (A).
1b.
Partially loosen preassembled set screws and
nuts in yoke at top of motor housing (D).
All manuals and user guides at all-guides.com
7
STANDARD MOUNT
4b
C
5
J
Plastic Motor Block
1a 1b
M
A
L
Yoke
D
Lowes.com/harborbreeze
ANGLE MOUNT
C
Open End
R
D
Set Screw
& Nut