Important - Harbor Breeze TILGHMAN Manual Del Usuario

INITIAL INSTALLATION
4a. Loosen canopy mounting screws (L) in slotted
holes in canopy (B) and remove the other two
canopy mounting screws (L) -- save canopy
mounting screws (L) for later use. Remove
mounting bracket (C) from canopy (B).
4b. Secure mounting bracket (C) to outlet box (not
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT: If using angle mount, make sure
open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
5. Remove motor screws (J) from underside of
motor and save for blade arm (H) attachment
later on. If there are plastic motor blocks
installed with the motor screws (J), discard the
plastic motor blocks.
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 on the next page. For
CLOSEMOUNT-STYLE FAN MOUNTING, skip
to page 10.
All manuals and user guides at all-guides.com
7
4a
C
L
4b
STANDARD
MOUNT
C
5
Lowes.com/harborbreeze
L
B
ANGLE
MOUNT
C
J