Mutsy i2 Manual Del Usuario página 29

Remove the seat (q)
· Slide the unlocking buttons upwards until you hear a click on both
sides. Be careful! The seat is now unlocked; the red section on the
chassis attachment points are now visible. The seat can vertically be
removed from the attachment points.
Adjust the back support (r)
· Pull the button at the back of the seat upwards and hold it upwards.
· The back support has 4 positions. Place the back support in the desired
position and release the button to lock the position.
Folding the chassis with the seat facing forwards (s)
· Stand behind the chassis and put the chassis on the brake. Fold the
hood back if it is folded out. Fold the seat unit in two by tilting the back
support forwards (s1).
· Push the height adjustment button (s2) of the pushbar in and move
this to the lowest setting. Pull the folding safeguard (s3) towards you
on both sides and turn the pushbar forwards until the pushbar lies on
the frame (s4).
· Pinch the chassis unlocking buttons and fold the chassis (s5).
· The folding safeguard locks automatically when the product is folded up.
· The integrated carry handle, which is located under the rear axle, has
made lifting and carrying the folded pushchair more practical.
· NB! The chassis cannot be folded with the seat facing backwards!
Unfolding the chassis with the seat
· Press the folding safeguard inwards (a1) and tilt the upper chassis until
the lower support clicks into place (a2) and move the pushbar
backwards until you hear a second click (b).
· After unfolding the seat, always push the bumper bar to its upright
position before placing a child in the seat. Make sure that no child is
near the bumper bar when moving it.
· Before use always check that the pram has been unfolded and secured
correctly.
Adjust the leg support (t2)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the leg support and push the leg
support downwards to lower it.
Attach and remove bumper bar (t1)
· To secure the front bumper, press the ends of the bumper into the
29