Relationship To The Authorities; Technical Data - Jotul Scan Andersen 10 Instrucciones Para Instalación

ENGLISH
Table of contents
Installation manual with technical data
1.0 Relationship to the authorities ................ 32
2.0 Technical data ............................................ 32
3.0 Safety .......................................................... 34
4.0 Installation ................................................. 34
5.0 Daily use ..................................................... 37
6.0 Service ........................................................ 38
7.0 Maintenance .............................................. 39
8.0 Operational problems
- troubleshooting ...................................... 39
9.0 Optional Equipment ................................. 40
10.0 Warranty .................................................... 40
The lot number and year are
marked on a label on all our
products. Write this number in the
place indicated.
If you need to contact your dealer,
you must always provide the
serial number and guarantee
card/receipt for the guarantee to
be valid.
32
1.0 Relationship to the
authorities
Installation of a fi replace must be according to local codes and
regulations in each country.
All local regulations, including those that refer to national and
European standards, shall be complied with when installing
the product.
Before use read the Installation and Operating Instructions
carefully. We recommend that the installed product be
inspected by a qualifi ed professional before use.
A heat-resistant rating plate is attached to the rear of the heat
shield. This contains information about identification and
documentation for the product.

2.0 Technical data

Material:
Finish:
Fuel:
Log length, max:
Flue outlet:
Flue pipe dimension:
Weight, convection model:
Weight, soapstone model:
Dimentions, distances:
Technical data according to EN 13240:
Nominal heat output:
Effi ciency:
Recommended chimney draught:
CO emision (13%O ):
2
CO emision (13%O ):
2
Operational type:
Intermittent combustion is here taken to mean normal use of
a fi replace. I.e. that a new fl ame chamber is lit as soon as the
fuel has burnt down to the appropriate quantity of embers.
Cast iron
Black paint
Wood
50 cm
Top/rear
Outside Ø 148/172 cm 2
inside Ø 135 mm/143 cm 2
approx. 140 kg
approx. 240 kg.
See Fig. 1
7 kW
79%
12 Pa
0,07%
3
875 mg/Nm
Intermittent