Publicidad
Idiomas disponibles
Idiomas disponibles
Install the K11 Faucet. See Figure 3.
1. Remove the hardware from the K11 faucet stem.
2. Slide the large rubber washer onto the threaded faucet stem.
3. Insert the threaded faucet stem assembly into the existing faucet
hole.
NOTICE: Make sure the large rubber washer and the base of the
faucet form a tight seal against the surface of the sink top.
4. From the underside of the sink, slide the large metal washer and
the nut over the threaded faucet stem.
5. Tighten the connection nut against the underside of the sink to
secure the faucet in place.
Figure 3
Reconnect the cold water line from
the filtering system to the faucet stem.
See Figure 4.
1. Cut (trim) a short section off the end of the poly tubing that was
in the old faucet.
2. To reconnect the water supply tubing as illustrated in Figure 4
firmly push the poly tubing all the way into the faucet stem until
firmly seated.
Trim (cut)
the end of
the tubing for
a new connection.
3705 0600 K11
Figure 4
Threaded Stem
of Faucet
Large Rubber
Washer
Existing Sink
Faucet Sprayer Hole
Drill a 3/4" diameter
hole or use the
existing faucet sprayer
hole.
Large Metal
Washer
Wing Nut
To connect:
Push the tubing
into the collet
ring in the
faucet stem.
Collet
Ring
Tubing
2
NOTICE: The faucet stem has a quick connecting fitting (See
Figure 4). If you need to remove the water line (poly tubing) from
the quick connecting fitting, simply push in the collet ring while
gently pulling the poly tubing out of the fitting (See Figure 5).
To remove the tubing:
Collet
Ring
Tubing
Figure 5
Turn the water back on:
1. Open the faucet and then slowly open the cold water shut off
valve.
2. To remove the air from the system run the water for 10 minutes,
or until the water runs clear of bubbles and air.
3. Check for leaks at all the fittings.
For further operating, installation, or
maintenance assistance:
Omnifilter
®
C
lean Water Solutions
293 Wright Street, Delavan, WI 53115
800-937-6664
www.omnifilter.com
Faucet
Stem
1
Push up on
the Collet
Ring.
2
Pull DOWN
on the tubing.
3699 0200 CR FS
TM
Publicidad
