Festool PLANEX LHS 225 EQ Manual De Instrucciones Original/Lista De Piezas De Repuesto página 22

Problem
Sanding grooves on
the surface
PLANEX switches
off during work – red
LED on the head of
the machine fl ashes
PLANEX does not
function
If other problems other than those listed occur, please contact your Festool service workshop or your
local specialist dealer.
22
Possible causes
Hard sanding pad set down on the
surface at an angle.
Sanding pad is too hard or abrasive
grit too coarse for very soft repair
compound.
Dust fi lter on PLANEX clogged
Excessive pressure -> machine acti-
vates overheating protection
Electrical plug is not connected cor-
rectly.
Remedy
Use sanding pad IP with interface pad.
Use sanding pad IP with interface pad.
Select a fi ner abrasive grit (Brilliant 2 abra-
sive with grit up to P 320).
Clean the dust fi lter on the PLANEX.
Allow the machine to cool and apply less
pressure; in extreme cases, switch on the
external extraction system and set the extrac-
tion control to setting 6.
Check that the electrical plug is inserted
properly.