For Prevention Of Water Leakage Accidents - Olympus PFL-E01 Manual De Instrucciones

For Prevention of Water Leakage Accidents

If water gets inside this product during use, irreparable damage may be caused to the
electronic flash inside the case. Please note the following points.
1. When sealing this product, make sure that no hairs, fibers, sand particles or other
foreign matter stick not only to the O-ring, but also to the contact surface. Even a single
hair or a single grain of sand may cause water leakage. Please check with special care.
2. The O-ring is a consumption product. Please replace it at least once a year by new
one. Also perform maintenance for every use.
3. Deterioration of the O-ring will progress according to the use conditions and the storage
conditions. Immediately replace the O-ring by a new one if it is damaged, shows cracks,
or has lost its elasticity.
4. At the time of O-ring maintenance, clean the inside of the O-ring groove and confirm the
absence of dirt, dust, sand, and other foreign matter.
5. Apply the specified silicone O-ring grease to the O-ring.
6. The waterproof function is not effective when the O-ring is not installed correctly. When
installing the O-ring, take care that it does not project from the groove and that it is not
twisted. Also, when sealing the Case, close the lid after confirming that the O-ring has
not come out of the groove.
7. This product is an airtight construction made of plastic (polycarbonate). When it is left
for a long time in a car, on a boat, at the beach, or at other places reaching a high
temperature, or when it is subjected for a long time to uneven external force, it may be
deformed and the waterproof function may be lost. Pay sufficient attention to
En
temperature control. Also do not place heavy objects onto the product during storage or
transport, and avoid unreasonable storage.
8. When the O-ring contact surface is pressed strongly from the outside of the Case, or
when the Case is twisted, the waterproof function may be lost. Take care not to exert
excessive force.
9. Please be sure to perform the advance test and the final test each time before using the
case.
10. If you see any drops of water or any other signs of water penetration during use, stop
the dive immediately. Carefully dry from the flash and waterproof case, and then
perform the "Final System Check" and confirm whether any water actually penetrated
this product.
Examples for foreign matter sticking to the O-ring
Hair Fibers Grains of sand
E-3