Olympus PFL-E01 Manual De Instrucciones página 31

WARNING
1. Keep this product out of the reach of babies, infants, and children. There is the
possibility of occurrence of the following types of accidents.
・Injury by dropping onto the body from a height.
・Injury from parts of the body getting caught in parts which open and close.
・Swallowing of small parts. Please consult a physician immediately if any parts have
been swallowed.
・Triggering of the flash in front of the eyes may cause permanent vision impairment etc.
2. Never store this product with an electronic flash with batteries inside. Battery leakage
could result in a fire or an explosion.
3. If water comes into contact with the electronic flash inside this product, remove the
batteries from the flash immediately. Otherwise, hydrogen gas could be produced, which
could lead to a fire or an explosion.
4. This product is made of resin. There is the possibility that injuries may be caused when it becomes
broken because of strong impact with a rock or other hard objects. Please handle with sufficient care.
5. The silica gel and the grease for silicone O-rings for this product are not edible.
CAUTION
1. Do not disassemble or modify this product. This may cause water leakage or trouble. In
case of disassembly or modification by persons other than those appointed by
OLYMPUS IMAGING CORP., the guarantee shall not apply.
2. Do not place this product at locations with abnormally high or abnormally low temperatures
or at locations with extreme temperature changes. The product may deteriorate.
3. Opening and closing at locations with much sand, dust, or dirt may impair the
waterproof characteristic and cause water leakage. This should be avoided.
4. This product is suitable for use at water pressures equivalent to depths of up to 60 meters.
Please note that diving at depths greater than 60 meters may result in deformation or damage
to this product, as well as to the camera and lens. In this case, water penetration may occur.
5. To prevent water leakage, do not handle the Case roughly. For example, do not throw
the Case overboard or dive into water while holding the Case in your hands. Be sure to
handle the Case carefully when passing it to another person.
6. If the electronic flash contained in the case gets wet, wipe off all moisture immediately
and check the flash is working correctly.
7. Before traveling by air, please make sure you remove the O-rings, otherwise the
difference in air pressure may make it impossible to open the case.
8. To ensure safe and trouble-free handling and operation of the electronic flash in this
product, please read the flash's instruction manual carefully.
9. When sealing this product, please take care to ensure no foreign matter such as sand,
dirt or hair is on the O-rings or contact surfaces.
10. Before storing this product, always be sure to take out the flash.
11. When using this product, do not fire the flash at close range to a person or animal.
Batteries
●The flash is powered by a pair of "AA"-size LR6 alkaline batteries, FR6 lithium batteries,
ZR6 nickel-manganese batteries, nickel-hydrogen (Ni-MH) batteries, nickel-cadmium (Ni-
Cd) batteries or ZR6Y "Oxyride" batteries. The flash can also be powered with a CR-V3
type lithium battery pack (Olympus Model LB-01).
●Keep the batteries' contacts away from damp and humidity to avoid impairing
performance and/or causing an accident.
●For other battery handling precautions, please read the relevant sections in the electronic
flash's instruction manual.
E-2
En