Viewing Images; Erasing Images During Playback (Single Image Erase) - Olympus TG-810 Manual Básico

Using the fl ash
1
Select the fl ash option in the shooting
function menu.
2
Use HI to select the setting option, and
press the A button to set.

Viewing images

1
Press the q button.
2
Use HI to select an image.
Erasing images during playback
(Single image erase)
1
Display the image you want to erase and
press G (  ).
2
Press FG to select [Erase], and press the
A button.
Important information about water
and shock resistant features
Before Use:
•
Check the camera for foreign material including dirt, dust or sand.
•
Firmly close the battery/card/connector cover lock and LOCK knob.
•
Do not open the battery/card/connector cover with wet hands, while under
water, or in a damp or dusty environment (e.g. beach).
After Use:
•
Be sure to wipe off any excess water or debris after using the camera
under water.
• After the camera is used under seawater, immerse the camera in a
bucket containing fresh water for about 10 minutes (with the battery/
card/connector cover fi rmly closed). After that, dry the camera in the
shade with good ventilation.
• Water drops may be observed on the inner surface of the battery/card/
connector cover after you open the cover. If any water drops are found,
be sure to wipe them off before using the camera.
Notes after use
•
Foreign materials may be attached to the camera when using the camera in
conditions with foreign materials such as dirt, dust or sand. If you continue to
use the camera in such conditions, it could cause damage to the camera. To
avoid such damage, wash the camera using the following method.
1 Insert the battery into the camera, and fi rmly close the
battery/card/connector cover lock and LOCK knob.
2 Fill a bucket or other container with fresh water,
immerse the camera facing downward in the bucket
and shake the camera thoroughly. Or rinse the camera
by placing it directly under a strong stream of tap water.
Storage and Maintenance
•
Do not leave the camera in an environment at high temperature (40°C
(104°F) or more) or at low temperature (-10°C (14°F) or less). Failure to do
so may break down water resistance.
•
Do not use chemicals for cleaning, rust prevention, anti-fogging, repairing,
etc. Failure to do so may break down water resistance.
• Do not leave the camera in water for a long time. Prolonged exposure to
water will cause damage to the camera's appearance and/or deteriorate
water resistance.
• In order to preserve the water resistant feature, as with any underwater
housing, it is recommended that the waterproof packing (and seals) are
replaced annually.
For the Olympus distributors or service stations where the waterproof
packing can be replaced, visit Olympus website for your local area.
Closing Battery/card/connector cover
Battery/card/connector cover
The included accessories (e.g. USB-AC adapter) do not
offer shock or water resistance.
5
EN