Wolf IR365PESPH Installation Guide página 11

O VEN O P E RAT I ON
Oven Operation
C L O C K
The clock is visible on the control panel during all cooking
modes, except when the timer is in use. It is very important
the clock is set to the correct time if the cook time or stop
time feature is used. The clock must be reset after a power
outage.
Setting clock:
Touch CLOCK on the control panel.
1
Use up and down arrows to set time of day. Time will
2
change from am to pm by passing 12:00.
Touch CLOCK. An audible chime indicates time has
3
been set.
To change to 24-hour clock, press and hold CLOCK for
4
5 seconds. Touch CLOCK, then ENTER.
C L O C K S TA NDB Y P O W E R
The range is shipped in standby power mode which dis-
ables the clock approximately 10 minutes after the cooling
fan operation is complete or the oven is inactive. The clock
will illuminate after any touch of the controls or oven use.
Enable | disable standby power:
Touch and hold CLOCK on the control panel for 5
1
seconds.
Touch STOP TIME to toggle on or off, then touch
2
ENTER.
TI MER
The timer on the oven control panel can be set for a
maximum of 9 hours, 59 minutes. Once a time is set, the
countdown is illuminated on the control panel display. The
last minute counts down in seconds. The timer is indepen-
dent from the oven. Setting the timer does not affect cook
time or stop time. For information regarding auto program
features, refer to page 14.
Setting timer:
Touch TIMER on the oven control panel.
1
Use up and down arrows to set time in hours and
2
minutes.
Touch TIMER to start. An audible chime indicates timer
3
has been set. Oven will chime and time will flash when
complete. Timer will continue to chime until CLEAR is
touched on the control panel.
|
wolfappliance.com 11