Wolf IR365PESPH Installation Guide página 17

SU R FA C E O P E RAT I O N
Surface Operation
POWE R L E VE L I ND I CAT O R
When an element is activated, a power level indicator will
illuminate above the corresponding control indicating the
level of heat. The lowest heat is represented by the small
flame, varying levels of heat by additional indicators (dots),
and the highest heat by all indicators including the large
flame. Refer to the chart and illustration below.
S ET T IN G PO WER L EV EL
Melt 1 (small flame)
indicator
Simmer 2–6 indicators
Medium 6–7 indicators
Medium High 7-8 indicators
High 8–10 (large flame)
indicators
Power level indicator.
U S ES
Melting butter, holding
chocolate and sauces.
Simmering sauces and
steaming rice.
Making French toast and
pancakes, heating milk, cream
sauces, soups and gravies.
Sauteing, browning and frying.
Boiling water, searing meat and
canning.
SI NG LE EL EMEN T | IN N ER ZO N E
Setting controls:
To activate a induction element, touch ON/OFF for the
1
desired single element on the control panel. Power level
indicator will flash and all indicators for that zone will
flash. Refer to the illustration below.
To complete the activation, touch HI for highest heat,
2
SIM (MLT) for lowest heat, BOOST to activate boost
mode, or touch desired power level indicator.
To change heat setting while the element is on, touch or
3
slide to desired power level.
To turn element off, touch ON/OFF.
4
If no cookware or an incompatible pan
IMPORTANT NOTE:
is placed on an induction element after activation, the con-
trol will flash for 30 seconds, then the element will turn off
automatically.
ON/OFF
Element activation.
|
wolfappliance.com 17