Worx BladeRunner WX570 Traducción De Las Instrucciones Originales página 10

ADDITIONAL SAfETY
INSTrUCTIONS fOr YOUr
Bladerunner
1. SAFETy PREcAUTION
1) Do not use saw blades which are damaged
or deformed;
2) Replace the table insert when worn;
3) Connect band saw to a dust-collecting
device when sawing wood;
4) Take care that the selection of the saw
blade and the speed depends on the
material to be cut;
5) Do not clean the saw blade whilst it is in
motion;
6) Wear suitable personal protective equipment,
when necessary, this could include:
– Hearing protection to reduce the risk of
induced hearing loss;
– Respiratory protection to reduce the risk of
inhalation of harmful dust;
– gloves for handling the saw band and
rough material.
2. SAFE OPERATION
1) During transportation the saw band guard
should be locked at fully down (close to the
10
table) position;
2) Do not use guard and its support system
for handling or transportation;
3) When cutting round timber use a suitable
holding device to prevent twisting of the
workpiece;
4) Any time after cutting, the knob for locking
blade guard shall be released so that the
guard is fully down to the table.
Multi-function saw
®
A GLOSSArY Of TErMS
1. cROSScUT
A cutting or shaping operation made across
the width of the work piece cutting the work
piece to length. Typically the cut is across the
wood grain.
2. RIPPING OR RIP cUT
A cutting operation along the length of the
work piece cutting the work piece to width.
Typically the cut is along the wood grain.
3. MITER cUT
A cutting operation made with the work piece
at any angle to the blade other than 90°.
1
2
3
CRoSS CUT
RIP CUT
mITeR CUT
EN