Ah 15 External Receiver; Rating Data; Operating Conditions; Working Instructions - SUHNER ABRASIVE WH 15 Documentación Técnica

2.2.3 c /d
onnecting etAching the sAfety guArd
The safety guard is available as an accessory.
Position the safety guard and fasten it in place with the
screw.
2.2.4 c /d
onnecting etAching on flexible shAft
Press the locking button, and insert the hose coupling
into the handpiece hole. Make sure that the locking button
is engaged. Disassembly must be carried out in reverse
order.
2.3 Ah 15
externAl receiver
The AH 15 external receiver is available as an accessory
and serves to enable the tool to be operated using both
hands.
2.3.1 c /d
onnecting etAching the tool
Loosen the nut and remove it with the pressure disc (1).
Fit the tool (2), refit the pressure disc, lock the spindle with
the spanner (3), tighten the nut (1).
2.3.2 c /d
onnecting etAching the externAl receiver
Insert the external receiver into the receiving hole on the
handpiece until it hits the limit stop (1). Lock the spin-
dle with the single open-ended spanner (2). Tighten the
threaded nut on the handpiece using the hook spanner
(3). Disassembly must be carried out in reverse order.
Fit handpiece on flexible shaft (see 2.2.4).
2.4 r
Ating dAtA
Connection
Maximum speed Input
Max wheel diameter
Spindle
Vibration EN 60745
Weight WH 15
Weight AH 15
The specified vibration value was measured with a
standardised test method and may differ from the
actual operating value. The specified value can be
used for product comparisons or for an introductory as-
sessment of work breaks.
2.5 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.
haNDLINg
3.1 w
orking instructions
Do not leave the tool running without a machine!
To achieve an optimum grinding result, move
grinding tool uniformly back and forth with light
pressure.
Excessive pressure lessens the working capability of the
hand tool, as well as the life of the grinding tool.
3.2 s on/off
witching
Hold the hand tool firmly. Switch on the drive.
Conduct the test run without load for at least thirty
seconds. Do not use vibrating grinding tools.
You must always hold the hand tool when it is op-
erating.
G35
5'000min
-1
200mm
MK2
6.2m/s , K=1.5m/s
2 2
2.000kg
2.450kg
/ o
PERaTIoN
21