Before Use; Charging The Battery; Inserting The Battery 6; Initializing The Vertical Circle 7 - Hilti POT 10 Manual De Instrucciones

7 Before use

7.1 Charging the battery

After unpacking the tool, remove the AC adapter, charger and battery from their holders.
Charge the battery for approx. 4 hours.
Illustration
en

7.2 Inserting the battery 6

Insert the charged battery into the tool with the battery connector underneath and facing the tool.
Secure the battery compartment cover carefully.

7.3 Initializing the vertical circle 7

After setting up the tool in accordance with the described procedure, the vertical circle of the tool must be initialized.
Tilt the telescope slowly about the trunnion (c) until an angle reading for vertical measurement is displayed.

7.4 Checking functions

NOTE
Please note that the locking knobs must be released before the tool can be pivoted about the alidade.
The horizontal and vertical drives also allow fine adjustment but must first be locked.
Check the functions of the tool before initial use and at regular intervals in accordance with the following criteria:
1. Release the locking knobs.
2. Rotate the tool carefully by hand to the left and right and tilt the telescope up and down to check that the parts
move smoothly.
3. Lock the horizontal and vertical drives and then turn the horizontal and vertical motion knobs carefully in both
directions.
4. Turn the focussing ring fully to the left.
5. Look through the telescope and turn the eyepiece ring to bring the cross hairs into focus.
6. With a little practice you can check the two optical sights on the telescope to ensure that they are in alignment
with the object targeted by the cross hairs.
7. Check that the screws on the carrying handle are tight.
8. See section: 7.3 Initializing the vertical circle 7

7.5 Setting up the tool

7.5.1 Setting up over a point on the ground

The tool is equipped with a laser plummet that is switched on and off together with the background light (if the tool is
already switched on).
32
Designation
POA 80 battery
POA 81 AC adapter
POA 82 charger