Aux In Jack & Encoding - JVC RD-F327B Manual De Instrucciones

3. Place the record on the platter and do not let the record touch the lid.
 Use the 45 rpm adaptor if you are playing 45 rpm records.
4. Unlock the tone arm from the rest, and then slowly move it to the record side. The platter will start to
rotate.
Arm lock
Tone arm locked
5. Put down the lift lever to drop the tone arm and touch the record gently. The phono will start playing the record.
6. Push the lift lever upward to raise the tone arm from the arm park, now platter will still be rotating but phono playing
will stop. To continue the playing, you need to put down the lift lever.
7. Adjust the volume to the desired level.
8. At the end of record, the platter will automatically stop rotating. Push the lift lever upward to raise the tone arm and
lock it on the rest, and then put down the lift lever.
9. To stop manually, lift the tone arm from the record and return it to the arm park.
REMARK: As some kind of record the auto-stop area was out of the unit setting, so it will stop before the last track finishes. In
this case, select the auto-stop switch to "off" position, then it will run to the end of the record but will not stop automatically
(turn off the unit by power button or switch back the auto-stop switch to "on" position to stop the platter rotating). Then put
back the tone arm to the arm park.
PHONO ENCODING
1. Press to enter the phono mode and then insert a memory device.
2. Press .

It will take 3-5 seconds to read the memory device.
3. Turn

The system will start encoding after a few seconds.
4. To finish encoding, press
REMARK:
- The recording speed is 1:1 according to the actual playing time of the phono.
- the recording format is preset at – mp3
AUX IN JACK & ENCODING
Press to enter the AUX mode, then connect the external audio device (such as a CD player) through the AUX IN
jack. Audio signal from the external audio device can be played through the system.
AUX IN ENCODING
1. Repeatedly press on the remote until the display shows "AUX", then insert a memory device.
2. Press .

It will take 3-5 seconds to read the memory device.
3. Turn
confirm.

The system will start encoding after a few seconds.
4. To finish encoding, press
REMARK:
- The recording speed is 1:1 according to the actual playing time of the external audio device.
- The recording format is preset at – mp3 bit rate: 128 kbps.
Tone arm unlocked
knob to select desired mode (USB or SD) for encoding. Then press
and the unit will return to the phono mode and the track is recorded in the "LINE_IN" folder.
bit rate: 128 kbps.
knob to select desired mode (USB or SD) for encoding. Then press
and the unit will return to the AUX mod and the track is recorded in the "LINE_IN" folder.
EN-7
to confirm.
to