Split Track Function For Usb/Sd Recording For Turntable/Aux In; Bluetootooth Connection; Earphone Jack & Line Out Jacks; Power Saving Feature - JVC RD-F327B Manual De Instrucciones

SPLIT TRACK FUNCTION FOR USB/SD RECORDING FOR TURNTABLE/AUX IN

1) Manual Split Operation Procedure: During recording, the USB/SD icon will flash on the display. If a new track is required,
press and the display will show "ts", then the unit will stop recording temporarily and resume again. A new
file representing a new track will be created on the USD device or SD card.
2) Auto Split Operation Procedure:

Before recording, select audio source, then press
auto split function has been activated. Then start USB/SD recording, the unit can automatically detect the silent part
between each track, and create a new file to move on to start recording the next track.

To deactivate auto split operation, press
"t-of".
NOTES:
 Several seconds of the beginning of the next track may not be recorded, as the unit may take a few seconds to create a new
file on the USB device or SD card.
 During recording from turntable to the USB device or SD card, when the unit has detected any particular silent part, the
turntable will stop temporarily. The turntable will resume operation once the USB device or SD card has begun creating a
new file to be recorded.

BLUETOOTOOTH CONNECTION

1. Repeatedly press
the Bluetooth mode.

The blue indicator will flash, indicating that the unit is ready for connecting with your
Bluetooth-enabled device.
2. Switch on the Bluetooth function of your Bluetooth device, and search "RD-F327B" for connection.
3. After connection is successful, the blue indicator light will stop flashing, then start to playback your device.
EARPHONE JACK & LINE OUT JACKS
This system can be connected with headphone or external amplifier / speaker by 3.5mm earphone jack.
This system can be connected with external device (e.g. amplifier and speaker) by LINE-OUT jacks at the rear of
the unit.

POWER SAVING FEATURE

To save energy, if there is no audio signal from CD / Turntable / AUX IN / USB / SD for a period of over 10 minutes, the unit will
automatically switch to the standby state.

SPECIFICATIONS:

Input: AC 100-240V~ 50Hz
Output: DC 12V 1A
Frequency range for AM: 522kHz-1620kHz
Frequency range for FM: 87.5MHZ-108MHZ
Frequency range: 2.402GHz - 2.480GHz
Transmitting power: 4dBm
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Trinovae Development (HK) Co., Ltd. is under license.
on the remote until the display shows "bt" or repeatedly press
EN-11
and the display will show "t-on", which means the
before recording and the display will show
to select