Worx WORXSAW XL WX429 Traducción De Las Instrucciones Originales página 14

TROUBLE SHOOTING
Symptom
Tool will not start when operating
the on/off trigger.
Cutting depth is less than that is
set.
Blade spins or slips.
Blade will not cut a straight line.
Blade kicks back when beginning
a cut.
14
Compact Circular Saw
Possible Causes
Safety switch is not pressed.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Saw blade teeth may be
engaged in the material when
starting.
Blade is not spinning fast
enough
Possible Solution
Press safety switch and hold it while
engaging the on/off trigger.
Check to make sure power cord is
connected well into a working outlet.
Unplug the power cord and replace it
using a qualified maintenance person.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade and reassemble
it as described in Mounting and
Removing the Blade section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Before restarting a saw in the
workpiece, center the saw blade in the
kerf and check that the saw teeth are
not engaged into the material.
Allow the saw blade to reach full
speed prior to beginning a cut in the
material.
EN