Kohler K-1095 Guia De Instalacion página 5

Large Tube Nut
Coupling Nut
Escutcheon
Fiber Washer
Rubber Seal
2. Install the Vacuum Breaker and Valve
For K-10959 Only
NOTE: Insert the components in the order specified.
Place the vacuum breaker into the tailpiece.
Place the fiber washer onto the vacuum breaker.
Slide the large tube nut over the bottom of the tailpiece and
tighten it to the valve body with a strap wrench.
Slide the coupling nut, escutcheon, fiber washer, and rubber seal
over the end of the tailpiece.
Handtighten the inlet arm nut to connect the valve body to the
control stop. Align the tailpiece with the toilet spud.
Slide the escutcheon over the spud.
Handtighten the coupling nut to the spud.
Plumb and tighten the valve to the control stop and the coupling
nut to the spud using a strap wrench.
Remove the tape covering the sensor eyes.
Turn on the water supply.
For K-10964 Only
Plumb and tighten the valve to the control stop and the large
tube nut to the vacuum breaker using a strap wrench.
Remove the tape covering the sensor eyes.
Kohler Co.
Valve Body
Inlet Arm Nut
Fiber
Washer
Vacuum
Breaker
Tailpiece
5
Control
Stop
1061437-2-C