Kohler K-1095 Guia De Instalacion página 6

Install the Vacuum Breaker and Valve (cont.)
Turn on the water supply.
3. Verify Valve Function
NOTE: The valve is programmed with a 24-hour cleaning feature.
Approach the fixture and stand in front of the sensor.
After ten seconds, step away from the fixture. After a short delay,
the valve should flush.
Confirm that the flush ends.
Later, verify that the valve performed the 24-hour cleaning flush.
NOTE: If required, troubleshoot according to the Troubleshooting
table.
1061437-2-C 6 Kohler Co.