D Devices D_SMALL CAL23 Manual De Instrucciones página 16

10.4. Change fuse (Fig 10-5)
a. Unplug the small steam sterilizer before changing the fuse
b. Unscrew the fuse holder with a screw driver counter clockwise.
c. After screwing the fuse holder, pull the fuse out.
d. Make sure to replace the faulty fuse with a correct fuse.
e. Put the correct fuse back to the fuse holder, plug into the holder lightly.
f. Put back the fuse holder and screw it on clockwise with a screw driver, make sure it will not pop-up.
10.5. Clean the seal plate periodically
After using some time, the seal plate might have some scale build-up that might cause leaking. You should
clean the seal plate periodically, using a soft cloth soaked with distilled water to wipe the rubber seal and the
seal plate clean (Fig 10-6 & 10-7). If there is still leaking, you may need to take the rubber seal out for cleaning.
Should the seal be broken, you need to change with a new one.
Figure 10-6
Remark: providing with seal packing collar for life.
10.6. Change of the seal
You will need a flat screw driver without a sharp tip. Pay attention about head ofthe flat screw driver. The install
step according to Fig 10-8.
16
54750_AUTOCLAVE_IFU-OK.indd 16
Figure 10-5
Figure 10-7
Figure 10-8
21/2/20 13:16