Installation - D Devices D_SMALL CAL23 Manual De Instrucciones

4. Installation

The The Small Steam Sterilizer should be installed in a drafty place allowing minimum of 10 cm space at all
sides and 50 cm at the top. The ventilation openings at the side of the machine should not be blocked. The
The Small Steam Sterilizer should be placed on a leveled counter top. The dimension of machine as the figure:
Caution: If the front of the machine is lower than the back the control will display "E3" (E3 means it
does not dry completely).
Preparation before using
We installed the draining filter before the device leaving factory. Clean
the draining filter once per month. You can see the instructions of how
to clean it according to page 15.
Before using the device, you should make electrical connections by
using the power cord that comes with the unit. Insert the hollowed end
of the power cord in to the inlet of the machine and plug the other end
on a power outlet. Caution: The power supply can afford 1800VA load.
Ok, you can turn on the The Small Steam Sterilizer now.
Caution: The power supply must be can afford (22L) 2300VA or (17L) 1800VA.
Tips: Before starting the Small Steam Sterilizer, please check on the local atmospheric pressure. lf the
pressure is lower than 0.095 Mpa or the Altitude is higher than 500 meters, you will need to contact your
distributor who should reconfigure the controller in the device.
6
54750_AUTOCLAVE_IFU-OK.indd 6 21/2/20 13:16