Working; Maintenance - Sirius SL85 Instrucciones Para La Instalación De Uso Y Mantenimiento

Filtering version
For the models SL85 and SLTC85: Fit the low-
er chimney to the product, as indicated in Fig.
8, then install the air outlet grill immediately
above the product as in Fig. 8 A.
For the models SL87 and SLTC 87: Install the
air outlet grill above the hood in the relative
seat (refer to Fig. 9). The stainless steel chim-
neys are not necessary.
For the model SL86: Using the supplied wall
plugs and screws, fix the tube support brack-
et (Des. 7) to the wall and/or the ceiling. The
bracket must be fixed in a central position in
respect of the air outlet flange. Fix the air de-
flector to the tube support bracket then con-
nect the air outlet of the motor to the deflec-
tor using a suitable tube (Des. 10).
Perform the electric connection.
Position the two tubes in the appropriate
seats above the cooker hood. Lift the internal
tube up to reach the tube support bracket.

WORKING

Mod. SL (dis. 11)
A: Light switch on/off
B: Motor switch on/off (1st rate level)
C: 2nd rate level switch
D: 3rd rate level switch
E: 4th rate level switch
F: 10 - minutes timer
Mod. SL TC – Glass (dis. 12)
A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 - minute timer
The touch control key allows the function de-
sired by touching the relative key.
If the electrical power supply to the product
SLTC is cut, 15 seconds are needed for self-
diagnostics after the functions are restored.
In the meanwhile, its operation may be incor-
rect.

MAINTENANCE

An accurate maintenance guarantees good
functioning and long-lasting performance.
Particular care is due to the grease filter. It
can be removed by following the instructions
below:
Act on the filter handle and rotate it out-
wards. To insert the filter just perform the
opposite operation.
After 30 hours working (model SL85 – SL87) ),
the push button control panel will signal the
saturation of the grease filter by lighting all
the buttons
For the models SL85TC and SL87TC Touch
Control Version: The saturation of the filter
is indicated by the flashing speed indicators
(Des. 12 C).
Press the timer button to reset.
To reset the simultaneous illumination of the
speed indicators, select the timing function
with the cooker hood switched off.
The grease filter needs cleaning by regular
hand-washing or in dishwashers ev ery two
months at least or depending on its use.
In case the appliance is used in its filtering
version, the active coal filter needs to be pe-
riodically replaced.
The charcoal filter is removed by removing
the grease filter first, following the instruc-
tions above, then by pulling its special plastic
tongue until it is released from its seat.
The charcoal filter is inserted by following the
reverse procedure.
To clean the appliance itself tepid water and
neutral detergent are recommended, while
abrasive products should be avoided.
The power cord shall be replaced by au-
thorized personnel only.
10