HP Designjet L26500 Información Preliminar página 11

Table 1
Error code
77:04
78.1:04
78.2:01
81:01, 81:03
82:01
86:01
98:03
ENWW
Numeric error messages (continued)
Recommendation
An Embedded Web Server internal software error has occurred. Try the
following remedies:
Turn off the printer by using the
●
power switch at the back of the printer. Disconnect the power cord, then
reconnect the power cord and turn on the printer.
Check that your printer firmware is up to date.
●
The printer has no substrate preset for this substrate. Follow the firmware
upgrade procedure to update the printer with the latest substrate presets.
The end of roll has been detected. If this is not the case, unload and reload
the substrate.
Open the printer window and make sure that there are no obstacles
restricting the movement of the drive roller. If the substrate has jammed and is
restricting the movement of the drive roller, see the Maintenance and
Troubleshooting Guide.
There may be a substrate jam, or a dirty carriage reflector. Try cleaning the
carriage reflector.
Open the window and check for any visible obstacles restricting the
movement of the printhead carriage. If there is a wrinkled mass of substrate
blocking the carriage, lift the substrate adjustment lever and clear the
obstruction.
One or more printheads is malfunctioning; use the printhead status plot to
find out which.
Power key on the front panel and the
Front-panel error messages
9