8.
Back
the upper level, or leave the option in the menu, or when given an option.
9.
Cancel
10. Reset
again). You will need an implement with a narrow tip to operate this key.
11. Move substrate
While the printer is printing, it can be used to fine-tune the substrate advance
on the fly.
To highlight an item in the front-panel display, press the
item is highlighted.
To select an item in the front-panel display, first highlight it and then press the
key.
When this guide shows a series of front-panel display items like this: Item1 >
Item2 > Item3, it means that you should select Item1, then select Item2, then
select Item3.
Information about specific uses of the front panel can be found throughout this
guide.
Front-panel error messages
Under certain circumstances, a front-panel error message appears. Follow the
advice in the Recommendation column to resolve the error. For details of
maintenance operations, see the Maintenance and Troubleshooting Guide.
Table 1
Error code
15.01:00, 16.01:00
15.02:00, 16.02:00
15.03:00, 16.03:00
15.04:00, 16.04:00
15.05:00, 16.05:00
ENWW
key: To go to the previous step in a procedure or interaction. To go to
key: To cancel a procedure or interaction.
key: To restart the printer (as if it were switched off and switched on
key: To move the loaded substrate forwards or backwards.
Numeric error messages
Recommendation
The printer is unable to warm up within a preset time limit. Check that the
ambient temperature and input voltage are within printer specifications.
The printer is unable to cool down within a preset time limit. Check that the
ambient temperature is within printer specifications. Check that all fans are
working and unblocked.
Excessive heat in the drying module. Check that all fans are working and
unblocked.
Insufficient heat in the drying module. Check that the ambient temperature is
within printer specifications.
Infrared sensor error. Check that all fans are working and unblocked.
Up
or
Down
Front-panel error messages
key until the
OK
5