LG PCS400R Servidor Pro:Centric Instalación Y Configuración página 49

The system will display a prompt for you to select the Pro:Centric portal application you will be using:
7 Either:
• Type and press
• Type and press
* Note: Select the appropriate application based on the purchase order associated with this server. The
software license specifies the Java or HTML application, and the application type must be set accordingly
in this step.
Once you make your selection, the server will display confirmation before initiating a reboot, for example:
8 When the reboot is complete, you should see a new login prompt. Log back in to the server (see step 6).
Once you are logged in, you will see a
The next step describes how to set static IP addresses for the Control Port and/or Feature Port, if desired/
applicable. The Control Port is used for remote management/communication purposes, while the Feature Port
is designated for PCS400R IP output (not applicable if your system is using RF or ASI output). By default, both
ports are configured for DHCP.
* Note: You can press
* Note: To view the server's current configuration settings, type
prompt. The System Information display will show the IP address that has been assigned to the Control
Port (if the network is configured for DHCP) and the output configuration. See "View System Information"
on page 26 for further information.
* Note: If the Control Port network is configured for DHCP but the Control Port IP address is not displayed
in the System Information display (see note above), refer to "Network Setup" troubleshooting information
on page 38. If configured, the DHCP server should assign an IP address to the Control Port once the
PCS400R successfully connects to the network.
to select the Java application.
to select the HTML application.
at any PCS400R command prompt to view current menu, if desired.
prompt
and press at the
21