Pcs400R Configuration Options; Network And Communication Setup - LG PCS400R Servidor Pro:Centric Instalación Y Configuración

PCS400R Configuration Options

Network and Communication Setup

This section describes PCS400R communication options for configuration purposes.
* Note: Before you proceed with any additional configuration, the PCS400R software should be
installed and configured as described in the setup procedure on pages 20 to 23.
Also note that configuration updates periodically require that you reset the PCS400R. Make sure to reset the
unit when directed to do so.
There are two typical options for communicating with the PCS400R:
• Use an SSH client to communicate with the PCS400R via a command line interface. If necessary, consult the
network administrator to obtain the IP address that has been assigned to/configured for the PCS400R's
Control Port.
• To establish a direct connection to the PCS400R, connect a PC to the PCS400R using the FTDI TTL-USB
cable (P/N TTL-232R-5V-AJ). Plug the USB end of the cable into an open USB port on your PC. If necessary,
install the device driver. Plug the other end of the cable into the Service Port jack on the PCS400R rear panel.
Using HyperTerminal or an equivalent terminal emulation program on the PC, configure the serial port as
follows:
-
-
-
-
-
* Note: To avoid configuration errors, make sure the keyboard settings on the terminal emulator assign the
backspace character to Ctrl + H (ASCII 8).
You will need to know the "admin" user password in order to log in to the command line interface. The default
admin user password is "Password4Partners" (case-sensitive). If necessary, for example, if the password has been
changed from its default value, consult the system administrator to obtain the current admin user password.
* Note: If you want to connect a PC directly to the PCS400R Control Port using an Ethernet CAT5E cable,
in order for communication to be established, the PCS400R's IP address must be on the same subnet as
the PC's IP address.
24