LG PCS400R Servidor Pro:Centric Instalación Y Configuración página 53

Log In to the PCS400R and Access the Main Menu
* Note: The PCS400R must be connected to an IP network for SSH client access. For direct access to the
PCS400R Service Port, use the FTDI TTL-USB cable (P/N TTL-232R-5V-AJ). See also "Network and
Communication Setup" above for further information.
1 Establish communication with the PCS400R using an SSH client or via a direct connection to the PCS400R
Service Port.
Once communication is established, you should see a login prompt. (If the login prompt is not automatically
displayed, press
2 At the login as: prompt, type
3 At the Password: prompt, type the admin password and press
4 At the prompt, either:
• Press to display the PCS400R Main Menu (see example below).
• Type the desired command and press
The following sections describe each of the configuration commands.
* Note: You can always press
Example: PCS400R Main Menu
to refresh the screen.)
and press
.
at the
.
.
prompt to display the PCS400R Main Menu.
25