LG PCS400R Servidor Pro:Centric Instalación Y Configuración página 57

8 Complete the following configuration:
Select/highlight
format xxx.xxx.xxx.xxx/xx, where the last two digits (after the forward slash) identify the network mask bits
for the IP address.
Also, type the gateway IP address (in the format xxx.xxx.xxx.xxx) in the Gateway field.
* Note: If you do not specify the network mask bits in the port's IP address, as indicated above, the system
will not create a local route over the network interface (unless the interface is used as the system's
default route).
• Select/highlight
the format xxx.xxx.xxx.xxx). As required, select
* Note: The Feature Port IP address MUST be on a different subnet than the Control Port IP
address.
9 (Recommended) Change the port configuration for IPv6 from Automatic to Ignore: Select/highlight the IPv6
Configuration field and press
10 When you are finished, select/highlight
.
11 Repeat steps 4 to 10 for the second port as required. When you are finished with port configuration, select/
highlight at the bottom right of the port selection screen and press
Manager menu. To exit the Network Manager and return to the Main Menu prompt, select
.
12 If you changed the port configuration, you will need to reset the system. If you are ready to reset the system
immediately, at the
for further information).
* Note: If you intend to modify additional configuration settings during the current session, you may wait
until all changes are complete before you reset the system.
and press in the Addresses field. Then, type the appropriate IP address in the
and press in the DNS Servers field, and type the primary DNS IP address (in
. Then, select
at the bottom right of the Edit Connection screen and press
prompt, type
again and type the secondary DNS IP address.
from the drop-down list of options.
and press (see "Reset the System" on page 37
to return to the Network
and press
29