Neck Curtains - MSA F1 SF Manual De Instrucciones

KITFIX
D
• Attach the mask using the "Kitfix" connector kits A and test mask seal
• To adjust mask tightness on helmet B:
– use a pair of pliers to remove the pin
– adjust the Kitfix to position (1) (2) or (3) (according to desired mask
tightness)
– use the pin to lock the Kitfix in place (push it fully in)

NECK CURTAINS

NECK CURTAINS (REAR PROTECTION ONLY)
E
• Place the neck curtain upside-down above the helmet.
• Place the three rear neck curtain fasteners in place then
clip (a).
E ' INTEGRAL NECK CURTAIN (FULL PROTECTION)
• Place the neck curtain upside-down above the helmet.
• Place the three rear neck curtain fasteners in place then clip (a).
Integral neckcurtain
GA1110
KITFIX
Put end of rail in the
lateral openings
A
B
(a)
Clic
Slide in Clip the textile
neckcurtain and tongue behind the
clip in rail to the small clip on the
two openings inner shell
A
B
GB
(1) (2) (3)
(1)
(2)
(3)
Clic
17