Chinstrap - MSA F1 SF Manual De Instrucciones

B
• The height at which the helmet is worn can be adjusted by changing
the depth of the cradle net. To do this, slide the 2 quick-fastening
straps through the holes in the back of the neck plate.
B'
Connection of front ratchet interface with inner shell
Default position:
Clip (A) inserted in inner shell tab (C)
Alternative position:
Clip (B) inserted in inner shell tab (C)
To unclip the connection (clip A or B), press down the securing lever
located on the inner shell tab (C), using a flat tool (e.g. screw driver) and
then pull upwards the front ratchet interface.

CHINSTRAP

C
• Lock the automatic buckle (a).
• Adjust chincup position using the adjustable side clips of the chinstrap side interfaces (b).
• Tense the chinstrap without overtightening (the two Velcro sections should be touching).
• Slide the chincup as required, to centre it. It is also allowed to completely remove it.
• Adjust tightness at the rear by pulling the 2 rear strands (c).
This helmet meets the retention requirements of EN 443:2008 when the chin strap provided by
the helmet manufacturer is worn and adjusted according to the instructions.
(a)
16
WEARING HEIGHT
WEARING ANGLE
ADJUSTMENT
(b)
To check that the helmet is
correctly adjusted:
The helmet should not fall off when
the head is leaning forward and the
chin strap unfastened.
(c)
The face shield should not touch the
nose.
A B C