MSA F1 SF Manual De Instrucciones página 29

INNER SHELL AND PADDING
• For reassembly of the intact inner padding make
sure the reinforcement layer is fixed properly
(marking shall be visible) on all 4 points.
• Raise the neck protector attachment and push it to release
the connection.
• Push the kitfix studs from the inside
of the shell out to remove them (a).
N.B.: to re-install them, the kitfix groove must
be placed in the shell groove and the stud
snapped into place in the front hole on the
shell. Ensure the screw that holds the assembly
is well tightened.
SHIELDS
3
FACE SHIELD AND OCULAR VISORS
The face shield and ocular visors and
their swivel pins can now be removed:
• Untight the left knob.
• Remove the left and right pins using a
screwdriver.
• Remove the right-hand fitting (with
lever) and remove the round pin from
the inside (lever upwards when the
ocular visors are raised).
• Unscrew the left-hand fitting and
remove the square pin.
• Bend the ocular visors to remove.
• Gather up the black spacer-type washers
(the long part for blocking the face shield is on the right-hand side).
• Release the face shield and remove it without scratching.
• Remove the white sealing washers remaining on the shell.
22
REAR CONNECTION
KITFIX
2
3a
(a)
1
3b