After-Sales Service - MSA F1 SF Manual De Instrucciones

FRONT PLATE
4
• Remove the front plate (2 screws).
N.B.: The front plate can be taken at any time during
disassembly, as long as care is taken to protect the face
shield using a soft cloth.
Your helmet is a Category 3 Personal Protective Equipment (PPE). MSA Gallet recommends to inspect it
at least every 2 years, by an authorised technician. For further information, contact your distributor.
Inspect each part of the helmet before and after each use, and all fixing points in particular.
■
correct anchorage
●
Make sure that the helmet is always correctly adjusted.
■
Use only genuine MSA GALLET parts to replace damaged elements, because they are the only approved parts, and
ensure the helmet meets the required standards.
The length of the useable life of this helmet will be affected by the type(s) of
material used in its construction and the environments in which the helmet is
used and stored. Recommendations on this topic should be sought from the
manufacturer.
All our models, accessories and spare parts are scrupulously checked before leaving the factory.
MSA GALLET‚ helmets and optional accessories come with a 2-year guarantee, including spare parts and labour, from the
date of purchase, for any malfunction that may occur, subject to observance of the terms and conditions set out in this
manual.
FRONT PLATE
AFTER SALES SERVICE
Maintenance, Spare parts
no visible wear no breakage
● ●
PRODUCT LIFETIME
WARRANTY
GB
23