MSA F1 SF Manual De Instrucciones página 28

RATCHET CRADLE
1
• Carefully undo the front and rear clips from their housing and remove the cradle.
To unclip the front connection press down the securing lever located on the inner shell tab, using
a flat tool (e.g. screw driver) and then pull upwards the front ratchet interface.
N.B.: For easy refitting, tighten the rapid adjustment system as much as possible.
REMOVING THE ASSEMBLY
NET
Release the net at the front at the same time as the front strap.
Release the net at the rear (a).
REAR CONNECTOR
Slightly bend the band and release the first stud then the
second.
INTERNAL CONNECTIONS
2
CHINSTRAP AND SUPPORTS
• Remove the screws from each side.
• Once screws have been released, remove
the chinstrap holders with a downward
motion away from the shell (a).
• Remove the keepers from each holder
to release the chinstrap (b).
• For reassembly make sure all parts are
connected correctly. Reinsert the screw
and tighten well, however without
overtightening it.
ACCESSORY INTERFACES
• From the inside of the helmet (a), push
the front section of the holders forward to
remove them (b).
CRADLE
(a)
(a)
GB
(a)
(b)
(b)
21