Aventics MSC Serie Instrucciones De Servicio página 22

AVENTICS | MSC | R41209736–BAL–001–AF | English
In the MG version, to reach the interior through holes (31),
you have to first remove the stroke limitation bolts (9). For
instructions see chapter "Roughly setting the stroke range
for forward strokes".
Mounting from below
O
Mount the mini slide on your mounting surface as illustrated in
the following figure.
33 "Mini slide" mounting screw
34 Centering ring
Piston Ø [mm] 8
Thread depth [mm] 9.5
Mounting with foot mountings
Mini slides with a piston diameter of Ø 20 mm and Ø 25 mm have
an additional slot for foot mountings
(see "13 Accessories"). This allows you to mount the mini slide to
the mounting surface with additional screws.
O
Insert the foot mounting in the slot (see the following figure)
and attach the foot mounting to the surface with suitable
screws.
34
33
12 16 20
11.5 17.5 16
Fastening the useful load
O
Observe tension-free installation of the useful load and plan
the subsequent replacement of parts.
O
Mount useful loads with or without centering rings on the slide
(1).
25
16
35 Mounting screw
36 Centering ring
O
Position the useful load on the slide in such a way that the
moment of tilt remains small.
M
35
1
21
M
M
35
36