Turning Scale On/Off - Uline OHAUS AVIATOR 7000 Manual Del Usuario

INSERTING THE BATTERIES
1. Make sure that the external power supply is
disconnected.
2. Remove the weighing pan.
3. Remove the battery compartment cover. (See Figure 1)
Figure 1
4. Turn over the scale and ensure that the battery
switch is set to the correct position.
a. For rechargeable D-cell
batteries: "NiMH" (See Figure 2)
b. For non-rechargeable D-cell
batteries: "Battery" (See Figure 2)
NOTE: Batteries are not included.

TURNING SCALE ON/OFF

1. To turn the scale on, press the ON/OFF key.
• After the scale is turned on, it runs through a short
display test. All segments and status messages
briefly light up and the software version is displayed.
• The scale is ready when the weight display appears.
2. To turn the scale off, press and hold the ON/OFF key
until a long beep can be heard.
PAGE 2 OF 39
Battery Compartment
Cover
Figure 2
NiMH
Battery
OPERATION
SETUP
WARNING! There is a risk of explosion when the
battery switch is not set correctly. Make
sure that the battery switch is in the
right position for the desired type of
battery.
5. Turn the scale right side up.
6. Place the batteries in the compartment so that the
positive poles face the springs. See pole markings
on cover and housing.
7. Close the battery compartment and put the
weighing pan back on.
CONNECTING TO MAIN POWER
The power supply is stored in a compartment under the
scale to support safe transport.
1. Connect the supplied power supply unit to the
power connection socket on the underside of the
scale.
2. Plug the power supply unit into a properly grounded
outlet.
FREE INPUT
You can immediately use your
scale for weighing and selling
without prior configuration.
1. Place the item on the
scale. (See Figure 3)
2. Enter the unit price. The
price to pay is displayed.
3. Remove the item from the
scale. All displays return to zero.
Enter the unit price as usual without the decimal point,
but with all the decimal places.
Figure 3
0 ... 9
0721 IH-5116