Fein KBM32Q Manual De Instrucciones página 14

3 41 01 011 21 0.book Seite 14 Montag, 8. Februar 2010 11:51 11
en
14
Starting and stopping the drill motor (Figure 8).
Starting:
Switch the motor switch on.
Stopping:
Switch the motor switch off.
Putting out of operation:
Switch off the magnet with the magnet
switch.
When the power supply is disconnected
while the motor is running, a protective cir-
cuit prevents automatic restarting of the
motor. Restart the motor again.
In case of overload, the motor automatically
stops and must be restarted again.
Feed (Figure 9).
Feed without the capstan handle.
Instructions for core drilling.
Punch-mark the marked drilling location.
Apply the drill bit via the centering pin onto
the punch mark.
Carefully start the drilling, until the cutting
surface has formed a circular shape.
Do not stop the drill motor during the
drilling procedure.
Only remove the core bit from of the drilling
hole while the motor is running.
If the core bit should remain stuck in the
material, stop the drill motor and carefully
turn the core bit out anti-clockwise.
Remove the chippings and the bored core
after each drilling process.
Fig. 8
Motor switch
Fig. 9
Do not touch the chippings with your
bare hand. Always use a chip hook.
When changing a drill bit, pay attention not to
damage the cutting edges.
When core drilling layered material, remove
the core and the chippings after drilling each
layer.
Capstan
handle