Lenco DAR-051 Manual De Usuario página 13

storage space, then press [ENTER] to confirm the desired preset number under which you will
store the station you are currently playing. Press [ENTER] to confirm.
FM Radio
Carefully extend the telescopic aerial to its full length.
Auto Scan
1 . Press the SOURCE key to select "FM".
2 . Long Press
sufficient signal strength.
3 . After a few seconds, the display will update. The display will show the station frequency. If the
signal is strong enough and the station signal contains RDS data, then the radio will display the
station name.
4 . To find other stations, press and hold the
5 . To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
6 . When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
Manual Scan
1 . Press the SOURCE key on the main unit to select "FM Mode''.
2 . Select FM mode as previously described, if required.
3 . Press or
down by 50 kHz.
4 . When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the reception
by doing another auto scan in a different location.
Menu
1 . Scan Setting
In FM mode, press MENU to enter the FM menu, then press
ENTER to select the sensitivity setting:
1 .1. All stations: 15dB~
1 .2. Strong stations only: 19dB~
2 . Audio Setting
button, and your radio will scan and stop automatically when it finds a station of
shortly adjust tuning. Each press of the tuning button will change the frequency up or
button as before.
or
- EN 13 -
to select [Scan setting], then press