Connect Supply Lines; Adjust Temperature With Water Running - Bradley Navigator S19-2010 Instalación

Installation
3

Connect Supply Lines

A
Thread the hot and cold supplies to 1/2" NPT
female threads.
B Install unions or union-function equivalent
fittings (hoses with swivel connectors) in the
inlet lines to facilitate valve removal.
C
SLOWLY pressurize the thermostatic mixing
valve and check for pipe leaks.
4

Adjust Temperature with Water Running

CAUTION This valve is not factory preset. Upon installation, the temperature of this valve must be
checked and adjusted to ensure delivery of a safe water temperature.
Faucet Temperature Adjustment
A
Loosen the cap screw approximately 1/4"
(4–6 turns counterclockwise) and lift up the
cover. DO NOT REMOVE THE COVER.
C
Push the cover down and tighten the cap
screw.
Bradley • 215-1873 Rev. B: ECO 20-09-002
Loosen cap screw.
COLD
HOT
B
Using the cover, gently turn the cartridge to
obtain the desired water temperature.
WARNING Water in excess of 110°F (43°C) may
cause scalding. Verify the water
temperature does not exceed this
temperature.
Do not turn past the stops as this may
damage the unit.
1/20/2020
S19-2010 Series
Using the cover, adjust
outlet temperature.
H C
5