Kohler K-702100 Manual Del Usuario página 9

Install outside
panel roller.
4. Install the Hanging Brackets
CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard
surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard
objects. Do not set unframed tempered glass directly on the floor.
Lay the inside door panel on a flat surface taking care to protect the glass. that the two holes located
in the bottom frame are in the up position.
Thread two provided # 8-18 x 3/8" panhead screws into the bottom frame approximately 1/4" (6
mm). Do not completely tighten at this time.
Insert a bushing into one of the holes at the top of the glass panels.
Install a hanging bracket over the glass panel, aligning the hole in the bracket with the bushing.
Repeat the steps to install the other three brackets.
Kohler Co.
Hanging Bracket
Roller
Blind Nut
Rollers on same side
as bottom frame hole
Rollers on same side
as bottom frame leg
8-32 x 3/8"
Machine Screw
Bolt
Bushing
8-18 x 3/8"
Panhead Screw
9
Install inside
panel roller.
1036566-2-F