Notes On Installation - Dometic CoolAir SPX1200I Instrucciones De Montaje

Ocultar thumbs Ver también para CoolAir SPX1200I:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Installation
I
NOTE
The connection line (3) can only be installed after fitting the evaporator unit and
the condenser unit.
6.2

Notes on installation

!
WARNING! Danger of electrocution!
• Detach all connections to battery before starting installation of parking
cooler.
• Make sure that all electrical components are electrically discharged before
carrying out work on them.
!
CAUTION!
Improper installation of the air conditioning roof unit can result in irreparable
damage to the device and put the safety of the user at risk.
The manufacturer will not be held liable for claims if the air conditioning roof
unit is not installed according to this installation manual. That applies to
malfunctions and the safety of the air conditioning roof unit, in particular to
injuries and damage to property.
I
NOTE
• The manufacturer strongly recommends the use of a vehicle-specific
fastening frame for an optimum installation procedure for the SPX1200C
condenser unit on the rear panel of the cab.
• Following installation of the unit, the specified unit software parameters
must then be checked (chapter "Configuration of unit software" on
page 12).
You should always read this installation manual all the way through before
installing the parking cooler.
You should always observe the following tips and information when installing the
parking cooler:
• Please consult the manufacturer of your vehicle with regard to the following.
– is the cab's rear panel a suitable location for attaching the unit?
– is the body designed to bear the static weight and loads occasioned by
the parking cooler in a moving vehicle?
• Check the dimensions of the unit (fig. 2).
• Always check before installation of the unit whether any vehicle components
could be damaged, deformed or impaired in terms of their functionality as a
result of the installation.
• Avoid any unnecessary and frequent mechanical stress to the supply line
between the evaporator unit and the condenser unit. Damage can result in
the loss of refrigerant and impair the performance of the unit.
8
CoolAir SPX1200I
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido